MicroCore-11 Accessories

Last update: 1 November 2005

MicroCore-11 Accessories

MicroCore-11 Quad Motor Driver Board:

2" x 2" standard MicroCore-11 form factor
based on SN754410 dual H-bridge chip plus logic
4 channels at 1 Amp per channel
drives four DC motors or two stepper motors
wire two channels in parallel for double the drive current
use 8 MCU output lines to control Enable and Direction of current through each H-bridge
9th MCU output line controls logic MOSFET for on/off control of solenoid, relay, DC motor, etc.
jumperable port pin assignments
includes LED direction indicators
separate connector for motor supply voltage (up to 24V)
on-board 5V regulator can power all logic and MicroCore-11
dual 26-pin bussed connector patterns for easy stacking
several connector options offer all the same configuration possibilities as Adapt11
use with prototyping board and backplanes, or stack with other boards
comes with schematic/mechanical/pinout drawing, motor chip data sheet, and application note

Order Online at http://www.technologicalarts.ca/index.php

Resources:

MicroCore-11 Motor Driver Board:

2" x 2" standard MicroCore-11 form factor
based on dual H-bridge chip plus logic
offered in both Standard (600mA per channel) and High-current (1 Amp per channel) versions
drives two DC motors or one stepper motor
cascadable-- add a second board for two more drivers
or wire two channels in parallel for double the drive current
four MCU output lines control enable and direction of current through each H-bridge
jumperable port pin assignments
LED direction indicators
separate connector for motor supply voltage (up to 24V)
on-board 5V regulator can power all logic and MicroCore-11
grid of plated-through holes on 0.1" centers for prototyping
dual 26-pin bussed connector patterns for easy stacking
several connector options offer all the same configuration possibilities as Adapt11
use with prototyping board and backplanes, or stack with other boards
comes with schematic/mechanical/pinout drawing, motor chip data sheet, and application note

Resources:

2" x 2" standard MicroCore-11 card size
grid of plated-through holes on 0.1" centers
dual 26-pin connector patterns for easy stacking
several connector options offer all the same configuration possibilities as Adapt11
use with MicroCore-11 backplanes, or stack with other MicroCore-11 boards

accepts up to four MicroCore-11 form-factor cards with -RA connector style, or one -SB and three -RA
for standalone use (corner mounting holes provided)
same configuration possibilities as Adapt11
use a MicroCore-11 module with one or more Application or Prototyping Cards

Technological Arts, Toronto, Canada

Toll-free: 1-877-963-8996 (USA and Canada) Phone: (416) 963-8996 Fax: (416) 963-9179
www.technologicalarts.com